Only in combination with P80 digital display.

The BP plate brake tester analyses the brakes of a vehicle under dynamic conditions of each individual wheel for the service- and parking brake. The brake forces and difference left/right of an axle can be measured.

The brake plates are designed for surface mount (on floor) or flush fitted (in floor) installation. The hot dip zinc bridge type brake plates are equipped with reliable roller bearings.

Available:
BP2: 2-plate brake tester.
BP2T: 2-plate brake tester with integrated sideslip meter.
BP4: 4-plate brake tester.
BP4T: 4-plate brake tester with integrated sideslip meter.

The important brake force ratio front axle to rear axle can also be determined on the BP4 and BP4T.

Required floor space:
1480 x 620 x 54 mm ( l x w x h): Single brake plate.
2180 x 2040 x 54 mm ( l x w x h): BP2
3140 x 2040 x 54 mm ( l x w x h): BP2T
4785 x 2040 x 54 mm ( l x w x h): BP4 and BP4T

With the optional integrated sideslip meter, during the brake test, the dynamic toe-in or toe-out of an axle is presented on the display. The mechanical compensation plate relieves any built-up tire forces which would impair the measurement. This guarantees an accurate sideslip test.