Attention: Your browser is not supported.
Attention: Your browser is outdated, so this website may not display properly.

Roller brake testers (on ground) RT2001-LP22 / RT2002-LP22

Single bed roller brake tester for passenger cars, vans and light commercial vehicles. FOR ON FLOOR and/or OUTDOOR INSTALLATION. The PERFECT solution to position ON FLOOR in front of a 4-post lift or on its own in combination with hot dip galvanised RAMPS.

ONLY 22 cm HIGH!

In addition to measure the brake forces per wheel and the difference between the left and right sides of an axle, the operator can determine the important quantities rolling resistance, actuation force, ovality (out-of-roundness) and brake fading for each wheel.

Special attention has been given to prevent damage to the tires. The rollers quickly stop when slippage occurs, even during the start-up of the motors. All roller brake testers are equipped with reliable worm gear motors.

The brake efficiencies (decelerations) of the vehicle are calculated automatically after manual vehicle weight input and can be compared with legal requirements for the service- and parking brake.

RT2002-LP22 + 4 ramps
  • High quality.
  • Reliable worm gear motors.
  • Hot dip zinc chassis.
  • Standard 4x4.
  • Only 22 cm high.
  • No damaged tires.
  • Extensive analysis.


Maximum axle load
3000 kg
Measuring range
6000 N
2 x 2,2 kW
Roller speed
2,5 km/h
Roller dimensions
700 x 206 mm
Maximum axle load
4000 kg
Measuring range
8000 N
2 x 5,5 kW
Roller speed
5 km/h
Roller dimensions
700 x 206 mm
All models
700-2200 mm
284 x 66 x 22 cm
Hot dip zinc
Power supply
3PH 400 V / 50 Hz


  • Roller cover plates, non pivoting
  • Steel rollers
  • Drive on/off ramps (set of 2). L=2m
  • Drive on/off ramps (set of 2). L=2,5m


RT2002-LP22  steel rollers
Steel rollers for tyres with spikes.
RT2002-LP22 Lift Ramps
Brake tester lay-out.
Free run roller set
Free run roller set.